Z6_EL9QHKG10GPM20IJGE61AK10O0
Z7_P86CH0O0I0RF10IB06HRVQ0087
Z7_EL9QHKG10GPM20IJGE61AK10S6
Z7_EL9QHKG10GPM20IJGE61AK10S5
Home  >  Mold Releases, Tooling Wax fillets & clay  > Partall Paste #2, Green Release Wax, 1-1/2 LB; silicone free.

Partall Paste #2, Green Release Wax, 1-1/2 LB; silicone free.

Item #: 128664 
Partall Paste #2, Green Release Wax, 1-1/2 LB. The original green wax, paste wax mold release compound, silicone free. There is no better protection for new or green molds.
21.31
Each
This item has been replaced by 
Item cannot be ordered
128664
 PARTALL Paste #2 is a general purpose polishing compound made from a blend of hydrocarbon and microcrystalline waxes. It is particularly recommended for use on molds where standard silicone waxes hinder post-finishing operations or as a primer coat to create a smooth mold surface prior to application of PARTALL Film #10. PARTALL Paste #2 may also be employed as an inexpensive edge wax on larger molds. 

Directions for Use: 


New / Reconditioned Molds: 

Using a clean dry cloth, apply a thin even coat of Partall Paste #2 to mold surface, covering 3-4 square foot sections at a time. Excess should be wiped away, also using a clean dry rag. Begin buffing immediately (approximately one minute after application) either by hand or with a power buffer equipped with a terry cloth or lamb’s wool pad. Keep power buffer moving constantly so as not to allow a build-up of friction that could burn through the wax coating. Surface should be buffed to a glossy finish. In order to insure complete coverage, repeat entire process 3-4 times for initial molding cycle. Alternate rubbing motions during application of each coat (i.e., up-down, left-right, circular). Apply one coat of PartallPaste #2 following each cycle thereafter until mold is broken in. Wait at least one hour after application of final coat before proceeding with molding. 

Seasoned Molds 

Using the same process described for new molds, apply one coat of Partall Paste #2 to mold surface and buff. Re-wax mold as necessary.

Mold Releases, Tooling Wax fillets & clay

Size
can
Liquid/Paste
Paste
Acetone, Quart
 
Item#:
129132
Manufacturer:
FGCI Website
Rags, Cotton, White Knit , Square Cut, 5 Pound Box; Excellent for polishing and cleaning, absorbent and almost lint free
 
Item#:
129384
Manufacturer:
FGCI Website
 
Wax Applicator, Micro Fiber, Round, 6" diameter; Our Micro Fiber Applicators are made with a soft inner sponge plus wrapped in a blue micro fiber cloth that will be a perfect fit for all detailers looking for that perfect applicator.
 
Item#:
131849