S2K Commerce - Products Dropdown
ActionsS2K Commerce - Order Entry
ActionsPartall #2, Green Release Wax, 7 lb Tub; silicone free.
Directions
for Use:
New / Reconditioned Molds:
Using a clean dry cloth, apply a thin even coat of
Partallï Paste #2 to
mold surface, covering 3-4 square foot sections at a time. Excess should be
wiped away, also using a clean dry rag. Begin buffing immediately (approximately
one minute after application) either by hand or with a power buffer equipped
with a terry cloth or lamb’s wool pad. Keep power buffer moving constantly so
as not to allow a build-up of friction that could burn through the wax coating.
Surface should be buffed to a glossy finish. In order to insure complete
coverage, repeat entire process 3-4 times for initial molding cycle. Alternate rubbing
motions during application of each coat (i.e., up-down, left-right, circular).
Apply one coat of PartallïPaste
#2 following each cycle thereafter until mold is broken in. Wait at least one
hour after application of final coat before proceeding with molding.
Seasoned Molds
Using the same process described for new molds, apply one
coat of Partallï Paste
#2 to mold surface and buff. Re-wax mold as necessary.