Z6_EL9QHKG10GPM20IJGE61AK10O0
Z7_P86CH0O0I0RF10IB06HRVQ0087
S2K Commerce - Products Dropdown
Actions
Z7_EL9QHKG10GPM20IJGE61AK10S5
S2K Commerce - Order Entry
Actions
Home
>
Resins, Polyester & Vinylester & Epoxy
> Non-Corrosive Epoxy, Curing Agent, 5:1 Ratio, EA-685B, Pint
Non-Corrosive Epoxy, Curing Agent, 5:1 Ratio, EA-685B, Pint
Item #:
125257
FGCI, Non Corrosive Activator, Part B, 100% Solids, 5:1, Mix well and do not vary ratio. Activators with lower ratios give Flex & Work Time; Higher Ratios give Hardness & Chem. Resistance, Pot Life @ 77F & .5 lb Mass: 10-15 Min., Pint
24.69
Each
Quantity:
Our 5 to 1 Laminating system is a two component 100 % solids
Epoxy resin system designed for coating, bonding, and the lamination of glass, carbon,
or kevlar fibers as used in the production of composite plastic products. This material features an
easy to use 5 to 1 by volume mix ratio that is (5 Parts Epoxy Resin to 1 Part of Activator by volume such
as liquid ounces, pints, quarts, or liters). The material itself features easy wet out, rapid cure, and
good adhesion to a variety of materials including wood, glass, metals and most other plastics. The
material cures to a very rigid, hard, amber colored plastic, with a high Heat
Distortion Temperature and will have good physical properties, good resistance
to water, and excellent resistance to chemicals and solvents. Thin films cured
in open air may blush .
As with all adhesive type compounds proper surface preparation is essential for good bond strength, recoating of the material should be accomplished before the material is fully cured after which sanding and solvent wash may be necessary for good secondary bonding.
As with all adhesive type compounds proper surface preparation is essential for good bond strength, recoating of the material should be accomplished before the material is fully cured after which sanding and solvent wash may be necessary for good secondary bonding.
Resins, Polyester & Vinylester & Epoxy
Size
Pint
Brand
Epoxy